Pollution degree
Pollution Degree 2 (as defined in IEC 61010-1). Note: Rated for indoor, dry
location use only.
Measurement and
overvoltage category
descriptions
Measurement terminals on this product may be rated for measuring mains
voltages from one or more of the following categories (see specific ratings
marked on the product and in the manual).
■
Measurement Category II. For measurements performed on circuits directly
connected to the low-voltage installation.
■
Measurement Category III. For measurements performed in the building
installation.
■
Measurement Category IV. For measurements performed at the source of
low-voltage installation.
NOTE. Only mains power supply circuits have an overvoltage category rating.
Only measurement circuits have a measurement category rating. Other circuits
within the product do not have either rating.
Mains overvoltage
category rating
Overvoltage Category II (as defined in IEC 61010-1)
Environmental considerations
This section provides information about the environmental impact of the product.
Restriction of hazardous
substances
Complies with RoHS2 Directive 2011/65/EU.
Product end-of-life
handling
Observe the following guidelines when recycling an instrument or component:
Equipment recycling. Production of this equipment required the extraction and use
of natural resources. The equipment may contain substances that could be
harmful to the environment or human health if improperly handled at the
product’s end of life. To avoid release of such substances into the environment
and to reduce the use of natural resources, we encourage you to recycle this
product in an appropriate system that will ensure that most of the materials are
reused or recycled appropriately.
Compliance information
xxii TBS1000C Series Oscilloscopes User Manual
To Next Page
Loading...
Need help?
General
