Setting or viewing USB Device port parameters
Disabling the USB Device port
Use this procedure to disconnect the USB Device port access, to prevent remote
access to the oscilloscope over the USB Device port connection.
NOTE. This function only disables the rear-panel USB Device port; it does not
disable the USB Host ports on the front and rear panel.
1. Push Utility front-panel button.
2. Push the Config side-menu button.
3. Use the Multipurpose knob to select and click USB.
4. Select and click Disabled (Off Bus).
TBS1000C Series Oscilloscopes User Manual 147
To Next Page
Loading...
