Setting the probe type voltage or current
The Probe Type submenu sets the type for probe that is connected to the
oscilloscope. The default probe type is Voltage. The other valid probe type is
current.
1. Push the Vertical Menu button for the channel input that you want to set.
2. Push the Probe Setup side menu to display the Probe Setup submenu.
3. Use the Multipurpose knob to select and click Probe Type submenu item.
4. Select and click the probe type (Voltage or Current).
Setting channel input parameters
48 TBS1000C Series Oscilloscopes User Manual
To Next Page
Loading...
