Tektronix TBS1000C Series

2. Push Feature Enable side-menu button.
3. Use the Multipurpose knob to select and click Autoset Enable.
4. Use the Multipurpose knob to select and click Change Password. The
oscilloscope opens the Change Password entry screen.
5. Use the Multipurpose knob and side-menu buttons to select alphanumeric
and enter characters for the current password. Then push the OK side-menu
button. The factory default password is 000000.
6. Use the Multipurpose knob and side-menu buttons to enter the new
password. Then push the OK side-menu button. Reenter the new password to
confirm it and push the OK side-menu button.
NOTE. The Autoset enable/disable can be done using the PI commands. Refer
Programmer manual for detailed instructions.
Acquisition setup
TBS1000C Series Oscilloscopes User Manual 69