General Safety Summary General Safety Summary
General Safety Summary
Review the following safety precautions to avoid injury and prevent damage to this product or any
products connected to it. To avoid potential hazards, use this product only as specified.
Only qualified personnel should perform service p rocedures. While using this product, you may need to
access other parts of the system.
Read the General Safety Summary in other system manuals for warnings and cautions related to operating
the system .
To avoid Fire a nd Personal Injury
Use Proper Power Cord. Use only the power cord specified for this product and certified for the country
of use.
Connect
and Disconnect Properly. Connect the probe output to the measurement oscilloscope before
connecting the probe to the circuit under test. Disconnect the probe input and the probe ground from the
circuit under test before disconnecting the probe from the measurement oscilloscope.
Ground the Product. This product is indirectly grounded through the grounding conductor of the
mainframe power cord. To avoid electric shock, the grounding conductor m ust be connected to earth
groun
d. Before making connections to the input or output terminals of the product, ensure that the product
is properly grounded.
Observe All Terminal Ratings. To avoid fire or shock hazard, observe all ratings and markings on the
product. Consult the product manual for further ratings information before making connections to the
product.
Use Proper AC Adapter. Use only the AC adapter specified for this product.
Use Proper Fuse. Use only the fuse type and rating specified for this product.
Do Not Operate With Suspected Failures. If you suspect there is damage to this product, have it inspected
b
yqualified service personnel.
Do Not Operate in Wet/Damp Conditions.
Do Not Operate in an Explosive Atmosphere.
Keep Product Surfaces Clean and Dry.
TDSUSB2 Universal Serial Bus Measurements Package 1
To Next Page
Loading...
Need help?
General
