Application Examples Selecting and Configuring Measurements-Inr ush Current Test
Selecting and Configuring Measurements-Inrush Current Test
From the application menu, select Measurement > Select > Inrush Current.
Configuring the Measurement
Follow the steps to con fi gure the selected measurement:
1. From the application menu, select Measurement > Configure > Configure tab.
2. Configure the following options:
Option Set to
Tier Tier is always set to 1
VBUS Enter voltage measured across VBUS manually
Device Type Hot P lug Attach
xxx
3. Select the Source tab.
80 TDSUSB2 Universal Serial Bus Measurements Package
To Next Page