System Manual 6. Maintenance
76.7300FP11/2, Rev A 8/09 Page 2-111
__ 5. For stubborn dirt, place a new optic prep on a flat and stable surface.
Hold the ferrule end so that it is on top of the optic prep. Clean the end
by moving the connector in a figure-8 pattern.
__ 6. Clean the connector end with a new dry wipe to help dry the ferrule
end. Wipe away any excess solution.
__ 7. Inspect the ferrule end with the fiber scope. If the dirt is still present
repeat steps 5, page 2-111 through 7, page 2-111.
__ 8. Insert the connector into the adapter.