. . . . .
ROUTINE MAINTENANCE
TP04300 Series Interface & Applications Manual 5-3
Section B:
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Inspection and Cleaning
Introduction Weekly inspection is recommended for frequently used systems to ensure normal operation
with no deterioration in performance.
1. Inspect exposed hoses and cables for cuts and or abrasions; reroute and repair as required.
2. Inspect for free air flow at all ventilated panel areas; remove any restrictions.
3. Inspect for open liquid containers resting on the system; remove when found. The system
is not waterproof.
4. Keep the system clean for reliable operation.
5. Clean the display using any commercially available CRT cleaner and a soft lint-free cloth.
Do not use any abrasive cleaner or paper towel.
6. Clean the condenser inlet every 3 months or sooner if needed. A dirty condenser inlet will
reduce the air flow and degrade the cooling performance of the refrigeration unit.
WARNING
WARNING 7: When cleaning condenser air inlet fins, (access by removing front panel) use
soft brush and/or vacuum cleaner, taking care not to bend inlet fins; as fins have sharp edges, to
prevent getting cut, either wear gloves and/or do not touch inlet fins directly with fingers.
7. Clean the front panel Operator Control Module (OCM) every 6 months or sooner if
needed. Use a soft, lint-free cloth or a ball of absorbent cotton, moistened with a mild
glass cleaner. Be careful not to get cleaning liquids into the OCM interior. Do not use a
paper towel; do not use enough liquid to drip or run.
To Next Page
Loading...
Need help?
General
