. . . . .
SYSTEM OPERATION
Stand Motion: Up/Down
TP04300 Series Interface & Applications Manual 3-7
Stand Motion: Up/Down
Introduction The two directional “STAND” membrane switches, upward ↑ and down ↓, are located on the
Thermal Head. These two switches raise and lower the vertical Stand post for a 16-inch
vertical travel. The manipulator assembly (the lower and upper arms) is attached to the
Vertical Stand post
WARNING
WARNING 5: During the up/down motion of the TP04300's head, keep your fingers out of
the space between the thermal cap (on the thermal head) and the DUT site.
CAUTION
CAUTION 4: Always hold the handle grips firmly on the head module while positioning the
head and or arm.
.
P000904.JPG
Generally, the manipulator (with the thermal Head in the down position) is lowered until the
Head’s thermal cap covers the DUT site.
NOTE: When the VERTICAL STAND LOCK is tightened, the STAND UP and DOWN
buttons are disabled.
Press, Hold:
Stand Upward,
16 inches maximum
Press, Hold:
Stand Downward,
16 inches maximum
Press,
Toggles Head
6 inches
Up / Down
on Head Slide
(Stand does
not move)
THERMAL
HEAD (Front)
To Next Page
Loading...
Need help?
General
