Previews 107
10. To select an initial condition interactively,
press:
Š
When prompted, enter t=40 and y1=45.
When selecting an initial condition
interactively, you can specify a value for t
other than the t
0
value entered in the
Y= Editor or Window Editor.
Instead of entering
t and y1 after pressing
Š
you can move the cursor to a point on the
screen and then press ¸.
You can use … to trace curves for initial
conditions specified in the
Y= Editor.
However, you cannot trace the curve for
an initial condition selected interactively.
Press Š 40 ¸ 45 ¸
Steps and keystrokes Display
To Next Page
Loading...
Need help?
General
