Differential Equation Graphing 422
enter a value from 0 through 10. However, the Fields graph format and the Axes setting
determine whether
ncurves is used.
When
ncurves is used, t0 is set temporarily at the middle of the Graph screen. However,
the value of
t0 as set in the Y= Editor or Window Editor is not changed.
Notes:
• Without entering initial conditions, use SLPFLD (with
ncurves=0) or DIRFLD to
display a slope or direction field only.
• SLPFLD is for a single 1st-order equation only. DIRFLD is for a 2nd-order equation
(or system of two 1st-order equations) only.
If Fields = Then:
SLPFLD Uses ncurves, if not set to 0, to graph curves.
DIRFLD Ignores ncurves. Does not graph any curves.
FLDOFF Uses ncurves if Axes = TIME (or if Axes = Custom and the
x axis is t). Otherwise, a Diff Eq setup error occurs.
To Next Page
Loading...
Need help?
General
