5.3. Setting up alarms
36
Alarm Description
GPS drift
correction
Triggered on startup as an informational reminder that
the GPS drift correct has been applied. Since GPS drift
varies with time this is a reminder that GPS drift
compensation may need to be recalculated.
GPS lost Triggered when the GPS signal is lost but the receiver is
still connected.
GPS
receiver
firmware
mismatch
Select the spanner to display the screen required to
update the applicable firmware.
Invalid
vehicle
profile
The selected vehicle profile contains invalid parameters.
Please create a new vehicle profile or contact your dealer
for assistance.
Invalid /
obsolete
profile
loaded
Triggered when an old implement or vehicle profile is
active on the system. This can occur if upgrading from a
very old version of the software to the latest version.
Liquid
pressure
high
Triggered if the tank pressure is greater than the
maximum specified tank pressure.
Liquid
pressure low
Triggered if the tank pressure is less than the minimum
specified tank pressure.
Low
resources
Triggered when the system resources (memory or space
on the file system) are more than 90% full.
Master
switch off
Triggered when the operator is driving over an area that
is untreated on the coverage map with the master switch
off. (To prevent operators from forgetting to engage the
master switch at the start of a run.)
To Next Page
Loading...