Chapter 5 – System Setup
37
Alarm Description
Max
guideline
length
exceeded
Triggered when the length of the recorded line exceeds
the maximum number of points (typically several
kilometres, but will vary based on how complex the
curve is).
No comms Triggered if the console is unable to communicate with
the implement ECU.
No GPS Triggered if the GPS connection is lost.
No GPS
time
Triggered if the GPS receiver is not configured to send
time messages (ZDA NMEA messages).
NTRIP
failure
GPS correction source failure.
Parameters
mismatch
Vehicle geometry parameters do not match the geometry
configuration in the steering system. Re-select the
vehicle on the Setup screen or ensure the vehicle
geometry in the vehicle geometry screen is correct.
Path too far
away
Triggered if the active guideline (AB line, curve or
pivot) is too far away from the current GPS position.
Project line
too far
Triggered if the active set of project lines is too far away
from the current GPS position.
Receiver
disconnected
The GPS receiver is not responding. Check the receiver
connections.
Registration
expiring
Registered feature expires within the next <days until
expiry> days. Please contact your dealer to renew
registration.
Resources
exhausted
Triggered if the system resources (memory or space on
the file system) are more than 97% full.
To Next Page
Loading...