CONTROLS
4-3736” & 40” Toro GrandStand Service Manual
4
4. Positionthebolt,spacer,andwasherintothecontrol
handle(Fig.317).
6. Looselyinstallthecableeyelettothelinkassembly
stud(Fig.319).
Note: This nut will be tightened in a later step.
Fig. 317 DSCN-3763a
5. Securethelinkassemblytothecontrolhandleusing
aangenut(Fig.318).
Fig. 318 DSCN-3766a
Fig. 319 DSCN-3770a
7. Routethecablearoundthepulleysandsecureto
thelinkassemblyusingthenutandjamnut,then
tightenthenutsecuringthecableeyelet(Fig.320).
Note: Do not over tension the cable. The speed
control handle must move freely, without the
cable binding on the pulleys.
Fig. 320 DSCN-3774a
To Next Page
Loading...
