Toro GrandStand 74534 - Page 105

CONTROLS
4-38 36” & 40” Toro GrandStand Service Manual
4
9. Position the slider assembly onto the control
assemblysotherodisnestedintheupperpulleys
(Fig.322).
Note: The cable tab must be located to the inside of
the cable (Fig. 323).
Fig. 321 DSCN-3779
Fig. 322 DSCN-3788a
Fig. 323 DSCN-3790a
10. Looselyinstallthebolt,nut,andcableclamptothe
slideassembly(Fig.324).
Note: This assembly will be tightened in a later step.
Fig. 324 DSCN-3796a
8. Securethesliderplatestothesliderassemblyusing
thefoursetsofbolts,spacers,andangenuts(Fig.
321).
Note: The base of the slider plates and the base of
the slider assembly MUST be level to each
other.