Toro GrandStand 74534 - Page 123

ENGINE
5-12 36” & 40” Toro GrandStand Service Manual
5
9. Using a feeler gauge, check the clutch air gap at
each of the three adjustment slots. Set the gap to
.015” (0.381mm). Make sure the gauge is inserted
between the armature and the rotor friction surfaces
(Fig. 383).
11. Apply thread locking compound to the threads of the
clutch bolt (Fig. 385).
Fig. 383 PICT-0554a
10. Install the spring washer (crown toward the bolt
head) and at washer to the clutch bolt (Fig. 384).
Fig. 384 IMG-9630a
Fig. 385 PICT-8700a
12. Torque the clutch bolt to 55 ft-lbs. (75 Nm) (Fig.
386).
Fig. 386 DSCN-2612a