Toro GrandStand 74534 - Page 130

ENGINE
5-1936” & 40” Toro GrandStand Service Manual
5
39. Install the starter wire to the solenoid using a lock
washer and nut. Torque nut to 35 in-lbs (4 Nm) (Fig.
413).
36. Make sure the mufer exhaust is centered in the
mufer guard assembly, then tighten all four bolts
and nuts. Torque the nuts to 19 ± 2 ft-lbs. (25.76 ±
2.7 Nm) (Fig. 410).
38. Install the battery ground wire and the wiring
harness ground wire to the engine block (Fig. 412).
Fig. 410 DSCN-2680a
37. Connect the clutch wire harness to the wire harness
(Fig. 411).
Fig. 411 DSCN-2686a
Fig. 412 DSCN-2688a
Fig. 413 DSCN-2533a