Toro GrandStand 74534 - Page 129

ENGINE
5-18 36” & 40” Toro GrandStand Service Manual
5
33. While holding the engine choke control lever in the
“Open” position, pull the slack from the cable jacket
and tighten the choke cable clamp (Fig. 407).
35. Position the mufer guard assembly and loosely
install the four carriage bolts, two mounting guard
brackets and nuts (Fig. 409).
34. Secure the throttle and choke cable to the oil drain
assemble using a cable tie (Fig. 408).
Fig. 406 DSCN-2677a
Fig. 407 IMG-0584a
Fig. 408 DSCN-2683a
Fig. 409 DSCN-2678a
32. Push the choke knob in so it is in the “Open” position
(Fig. 406).