Toro GrandStand 74534 - Page 128

ENGINE
5-1736” & 40” Toro GrandStand Service Manual
5
31. Hook the “Z” bend of the choke cable into the choke
control lever and loosely clamp the outer housing of
the choke cable with the cable clamp (Fig. 405).
27. Install the belt covers.
28. Hook the “Z” bend of the throttle cable into the
throttle control lever and loosely clamp the outer
housing of the throttle cable with the cable clamp
(Fig. 402).
30. With the engine throttle control lever in the “Fast”
position, pull the slack from the cable jacket and
tighten the throttle cable clamp (Fig. 404).
Fig. 402 DSCN-2672a
29. Move the throttle lever to the “Fast” position (Fig.
403).
Fig. 403 DSCN-2674a
Fig. 404 IMG-0576a
Fig. 405 DSCN-2676a