Toro GrandStand 74534 - Page 141

HYDRAULIC DRIVE SYSTEM
6-8 36” & 40” Toro GrandStand Service Manual
6
8. Removethebeltfromaroundthepumppulley(Fig.
447).
9. Remove the two set screws securing the pump
pulley to the pulley shaft, then remove the pulley
(Fig.448).
10. Remove the key from the pulley shaft keyway (Fig.
449).
Fig. 447 DSCN-2962a
Fig. 448 DSCN-2965a
Fig. 449 DSCN-2971a
11. Remove the bolt and nut securing the control cable
to the pump control arm (Fig. 450).
Fig. 450 DSCN-2978a