Toro GrandStand 74534 - Page 145

HYDRAULIC DRIVE SYSTEM
6-12 36” & 40” Toro GrandStand Service Manual
6
4. Installthereturnhosetting,orientateasshown,
then secure the position using the jam nut (Fig. 463).
Fig. 463 DSCN-3029a
6. Securethereturnhosetothepumpttingusingthe
hose clamp (Fig. 465).
Fig. 465 DSCN-3049a
5. Secure the pump to the engine base using the
carriage bolts, washers and nuts (Fig. 464).
Fig. 464 DSCN-3045a
7. Securethesuctionhosetothepumptting(Fig.
466).
Note: Securethepositionofthettingusingthe
jam nut.
Fig. 466 DSCN-3051a