Toro GrandStand 74534 - Page 146

HYDRAULIC DRIVE SYSTEM
6-1336” & 40” Toro GrandStand Service Manual
6
8. Installthehighpressurehosetothepump(Fig.
467).
Note: Ensure the hose is installed to the correct
pumpttingbyusingtheidenticationmark
ings. If installed incorrectly, wheel direction
will be reversed.
Fig. 467 DSCN-3052a
9. Loop the hose around the control cables and
oppositesidepumphoses(Fig.468).
Fig. 468 DSCN-3055a
10. Install the hose to the wheel motor (Fig. 469).
Note: Ensure the hose is installed to the correct
wheelmotorttingbyusingtheidentication
markings. If installed incorrectly, wheel
direction will be reversed.
Fig. 469 DSCN-3057a