Toro GrandStand 74534 - Page 148

HYDRAULIC DRIVE SYSTEM
6-1536” & 40” Toro GrandStand Service Manual
6
15. Install the key into the keyway on the pump shaft
(Fig. 474).
17. Apply thread-locking material to the threads of the
pump pulley set screws (Fig. 476).
Fig. 474 DSCN-2971a
16. Apply anti-seize to the pump shaft (Fig. 475).
Fig. 475 DSCN-3079a
Fig. 476 DSCN-3069a
18. Installthesetscrewsintothepumppulley(Fig.477).
Note: Ensure the set screws have not protruded
into the center of the pulley hub.
Fig. 477 DSCN-3071a