Toro GrandStand 74534 - Page 165

HYDRAULIC DRIVE SYSTEM
6-32 36” & 40” Toro GrandStand Service Manual
6
4. Raise the rear of the machine and secure with jack
stands (Fig. 534).
9. Position a drain pain under the wheel motor.
10. Disconnect both hydraulic hoses from the wheel
motor (Fig. 537).
7. Thoroughly clean the area around the hydraulic
ttingstopreventdebrisfromenteringthesystem.
8. Markthehosesandcorrespondingwheelmotor
ttingportssothehosesgetconnectedbackintheir
original locations (Fig. 536).
Fig. 534 DSCN-2811a
5. Release the parking brake.
6. Remove the 4 lug nuts and the wheel assembly (Fig.
535).
Fig. 535 DSCN-2805a
Fig. 536 DSCN-2830a
Fig. 537 DSCN-2833a