Toro GrandStand 74534 - Page 178

MOWER DECK
7-936” & 40” Toro GrandStand Service Manual
7
3. Remove the spindle shaft and blade from the spindle
housing (Fig. 573).
Fig. 573 DSCN-3179a
4. Withthespindleshaftrmlysecuredinavise,
remove the nut and washer securing the blade to the
spindle shaft (Fig. 574).
Fig. 574 DSCN-3184a
5. Remove the upper and lower bearings from the
spindle housing (Fig. 575).
Fig. 575 DSCN-3185a
6. Remove the bearing spacer from the spindle
housing (Fig. 576).
Note: Inspect all spindle assembly components.
Replace any that are damaged or worn.
Fig. 576 DSCN-3191a