Toro GrandStand 74534 - Page 179

MOWER DECK
7-10 36” & 40” Toro GrandStand Service Manual
7
9. Withthebearingspacercenteredinthehousing,ll
the cavity between the spacer and housing with high
temp grease (Fig. 579).
8. Positionthebearingspacerinthespindlehousing
(Fig.578).
Fig. 578 DSCN-3195a
Fig. 579 DSCN-3198a
10. Install the lower bearing into the spindle housing and
add a couple of pumps of high temp grease to the
centerofthebearingspacer.(Fig.580).
Fig. 580 DSCN-3202a
7. Install the upper bearing into the spindle housing
(Fig. 577).
Fig. 577 DSCN-3193a