Toro GrandStand 74534 - Page 180

MOWER DECK
7-1136” & 40” Toro GrandStand Service Manual
7
12. Positionthebearingshieldontothetopofthe
spindlehousing(Fig.582).
Fig. 582 DSCN-3207a
13. Secure the pulley to the spindle shaft using the
washerandnut.Thetorquewillbeappliedinalater
step(Fig.583).
Note: The welded side of the pulley hub faces
upward.
Fig. 583 DSCN-3158a
11. Install the spindle shaft into the spindle housing (Fig.
581).
Note: Rotate the spindle shaft as it is inserted
through the spindle housing to spread the
grease.
Fig. 581 DSCN-3205a