Toro GrandStand 74534 - Page 238

ELECTRICAL
8-1736” & 40” Toro GrandStand Service Manual
8
13. Unplug the clutch wires from the wiring harness (Fig.
766).
Fig. 766 DSCN-2536a
12. Remove nut and lock washer securing the starter
wire to the solenoid (Fig. 765).
14. Push the grommet and the electrical plug connector
down through the engine base (Fig. 767).
Fig. 765 DSCN-2533a
Fig. 767 DSCN-2547
15. Remove the four nuts, two mounting guard brackets
and four carriage bolts securing the mufer guard
assembly to the front frame, then remove the mufer
guard (Fig. 768).
Fig. 768 DSCN-2549