Toro GrandStand 74534 - Lubrication Procedures

CHASSIS
3-936” & 40” Toro GrandStand Service Manual
3
20. Install a grease zerk into the port on the side of the
pivot hub (Fig. 032).
22. Replace the grease zerk with the plug (Fig. 034).
Fig. 032 DSCN-0434a
21. Fill the pivot hub cavity until grease is purging out
through the upper bearing (Fig. 033).
Fig. 033 DSCN-0438a
Fig. 034 DSCN-0436a
23. Install the grease cap onto the top of the pivot hub
(Fig. 035).
Fig. 035 DSCN-3918a