Toro GrandStand 74534 - Component Access for Maintenance

CHASSIS
3-8 36” & 40” Toro GrandStand Service Manual
3
16. Position the caster wheel and fork assembly up
through the pivot hub.
17. Secure the caster wheel and fork assembly with the
nut (Fig. 030).
Fig. 028 DSCN-3924a
Note: Bottom: Crown Up / Middle: Crown Down /
Top: Crown up (Fig. 029).
Fig. 029 DSCN-0423a
Fig. 030 DSCN-0360a
18. Tightenlocknutuntilspringwashersareat(15ft-lbs
/ 20 Nm) and then back off a 1/4 turn to properly set
the pre-load on the bearings.
19. Remove the plug from the side of the pivot hub (Fig.
031).
Fig. 031 DSCN-0436a
15. Install the 3 Bellville washers into the pivot tube (Fig.
028).