Toro GrandStand 74534 - Cleaning and Storage Procedures; Cleaning and Storage Guidelines

CHASSIS
3-36 36” & 40” Toro GrandStand Service Manual
3
A. Hydraulic pumps D. Clutch retainer
B. Idler pulley E. Pump drive belt
C. Clutch pulley F. Pump drive pulley
18. Position the pump drive belt around the engine, idler
and pump pulleys (Fig. 140).
Fig. 138 DSCN-4150a
17. Install the pulley onto the pump shaft. The base of
thepulleyhubshouldbeushwiththebaseofthe
pump shaft. Secure the position with the set screws
(Fig. 139).
Fig. 139 DSCN-4159a
Fig. 140 g.67G012686
19. Install the extension spring from the idler bracket to
the spring anchor (Fig. 141).
Fig. 141 DSCN-4155
16. Install the set screws into the pump pulley (Fig. 138).
Note: Ensure the set screws have not protruded
into the center of the pulley hub.
A
B
C
D
E
F