Toro GrandStand 74534 - Page 78

CONTROLS
4-1136” & 40” Toro GrandStand Service Manual
4
A. .05”to.09”(1.27to2.29mm)
13. Securethepositionoftheswitchbytighteningthe
twomountingscrews(Fig.220).
15. Positiontheneutralswitchboltsothegapbetween
it and the switch is between .05” and .09” (1.27 and
2.29mm).Securethepositionusingthejamnut(Fig.
222).
Fig. 220 DSCN-3666a
14. Secure the control cable to the motion control lever
usingashoulderboltandangenut(Fig.221).
Fig. 221 DSCN-3610a
Fig. 222 DSCN-3668a
A