Toro Reelmaster 3100-D - Page 188

RemovingtheHydraulicManifoldAssembly(continued)
1.Parkthemachineonalevelsurface.Lowercuttingunits,stopengineand
engageparkingbrake.Removekeyfromthekeyswitch.
2.ReadtheGeneralPrecautionsforRemovingandInstallingHydraulicSystem
Components(page5–62).
3.Topreventcontaminationofthehydraulicsystemduringmanifoldremoval,
thoroughlycleanexteriorofmowcontrolmanifoldandttings.
4.Disconnectthewireharnessconnectorfromthehydraulicmanifold.
5.Disconnectthehydrauliclinesfrommanifoldandputcapsorplugsonopen
hydrauliclinesandttings.Labeldisconnectedhydrauliclinesforproper
installation.
6.Removethetwo(2)nutsunderthemanifoldthatsecurethemanifoldto
theframe.
7.Ifhydraulicttingsaretoberemovedfrommanifold,markttingorientationto
allowcorrectassembly.RemovettingsfrommanifoldanddiscardO−rings.
InstallingtheHydraulicManifoldAssembly
1.Ifttingswereremovedfrommowcontrolmanifold,lubricateandplacenew
O−ringsontottings.Installttingsintomanifoldopeningsusingmarksmade
duringtheremovalprocesstoproperlyorientatettings.Tightenttings
(seeInstallingtheHydraulicFittings(SAEStraightThreadO-RingFittings)
(page5–8)).
2.Installthemowcontrolmanifoldtotheframe.
3.Removethecapsandplugsfromttingsandhoses.Usinglabelsplaced
duringmanifoldremoval,properlyconnecthydrauliclinestomanifold(see
InstallingHydraulicHosesandTubes(O-RingFaceSealFittings)(page
5–6)).
4.Connectwireharnessconnectortothehydraulicmanifold.
5.Makesurehydraulictankisfull.Addcorrectuidifnecessarybefore
returningmachinetoservice.
HydraulicSystem:ServiceandRepairs
Page5–112
Reelmaster
®
3100-D/3105-D
20252SLRevA