Toro Reelmaster 3100-D - Reel Assembly Service

ReelAssemblyService
g343570
Figure182
1.Cuttingreel5.Specialwasher9.GrooveindicatingLHthreads
2.Threadedinsert(RHthread)
6.Flockedseal10.Reelspider
3.Plasticplug(2)7.Sealedbearing
11.Retainingringgroove
4.Retainingring
8.Threadedinsert(LHthread)
12.Bearingshoulder
InspectingtheCuttingReel
1.Inspectthereelbearingstoinsurethattheyspinfreelyandhaveminimal
axialplay.
2.Inspectthereelshaftasfollows.Ifthereeldamageisdetected,replacereel.
A.Checkthereelshaftforbendinganddistortionbyplacingtheshaftends
inV-blocks.
B.Checkthereelbladesforbendingorcracking.
C.Checktheservicelimitofthereeldiameter(refertoPreparingtheReel
forGrinding(page8–29)).
3.Checkthethreadedinsertsinthereelshaftforexcessivewearordistortion.
Replacetheinsertsifdamageisevident.
A.OneinserthasLHthreadsandtheotherinserthasRHthreads.The
insertwithLHthreadshasagrooveontheinsertface.Agrooveiscutin
theendofthereelshaftthathasLHthreads.
DPACuttingUnits:ServiceandRepairs
Page8–26
Reelmaster
®
3100-D/3105-D
20252SLRevA