Toro Reelmaster 3100-D - Rear Roller

RearRoller
g214395
Figure188
1.Rearrollerassembly
4.Flangenut(2each)
2.Rearrollerbracket
5.Rollershim(2each)
3.Carriagescrew(2each)6.0.010inchshim(ifnecessary)
RemovingtheRearRoller(Figure188)
1.Positionmachineonacleanandlevelsurface,lowercuttingunits,stop
engine,engageparkingbrakeandremovekeyfromthekeyswitch.
2.Removethecuttingunitfromthemachineandplaceonalevelworking
surface.Placesupportblocksunderbedbartoraiserearrollerfromwork
surface.
3.Loosentwo(2)angenutsthatsecuretherearrollershafttoeachrearroller
bracket.
4.Ononeoftherearrollerbrackets:
Note:OncuttingunitsequippedwithoptionalHighHeightofCutKit,there
willbeadditionalrollershimsinstalledbetweenrearrollerbracketandcutting
unitsideplate.
A.Removeangenutsandcarriagescrewsthatsecurerearrollerbracket
androllershimstothecuttingunitsideplate.
B.Removetherollerbracketandrollershimsfromtherearrollerandcutting
unit.
5.Slidetherearrollerassemblyfromtheremainingrearrollerbracketonthe
cuttingunit.
6.Ifnecessary,removethesecondrearrollerbracketandrollershimsfrom
thecuttingunit.
InstallingtheRearRoller(Figure188)
1.Placecuttingunitonalevelworkingsurface.
Note:RefertoCuttingUnitOperator’sManualfornumberofrollershims
requiredforvariousheightofcutsettings.
Note:A0.010”shim(partnumber107-4001)isavailabletoallowforleveling
oftherearroller(refertoLevelingRearRoller(page8–4)).Ifnecessary,this
shimwouldbeusedononesideoftherearrollerandshouldbeinstalled
betweentherearrollerbracketandrollershim.
2.Ifbothrearrollerbracketswereremovedfromthecuttingunitsideplate,
positionbracketsandrollershimstooneofthesideplates.Installtwo(2)
DPACuttingUnits:ServiceandRepairs
Page8–34
Reelmaster
®
3100-D/3105-D
20252SLRevA