Toro Reelmaster 3100-D - Page 335

InspectingtheCuttingReel(continued)
B.Usecorrectsplineinserttooltoremovethreadedinserts(refertoSpecial
Tools(page2–13)).
AssemblingtheCuttingReel
g343571
Figure183
1.Reelshaft2.Plasticplug(2each)
1.Ifremoved,installnewreelshaftplugsintocuttingreelshaft.Forcuttingunit
serialno.priorto315000001,makesureplasticplugispressedushinto
endofthreadedinsert.Forcuttingunitserialno.315000001&Up,make
sureplasticplugispresseduntoreelshaft41to35mm(1.63to1.37in.)
belowtheendoftheshaft(Figure183).
Note:OneinserthasLHthreadsandtheotherinserthasRHthreads.The
insertwithLHthreadshasagrooveontheinsertface.Agrooveiscutinthe
endofthereelshaftthathasLHthreads.
2.Ifpreviouslyremoved,usecorrectsplineinserttooltoinstallthreadedinserts
(refertoSpecialT ools(page2–13)).Applythreadlockingcompound(Loctite
#243orequivalent)tothreadedportionofinsert.Tightenthreadedinsert
from115to128N·m(85to95ft-lb).
3.Makesurethatthetwo(2)retainingringsarefullyseatedintothegrooveson
thecuttingreelshaft.
4.Carefullydrivespecialwashersontoreelshaftwithtaperedsideofwashers
towardreel(atsidetowardbearinglocation).Installedwashersshouldbe
tightagainstretainingringandshouldnotwobbleasthereelisrotated.
IMPORTANT
Theockedsealshouldbeinstalledsotheocked(red)sideofthe
sealistowardthebearinglocation.
5.Slideockedseals(ocked(red)sideorientatedtowardbearinglocation)
andbearingsfullyontoreelshaft.Flockedsealsandbearingsshouldbottom
onreelshaftshoulder.
Reelmaster
®
3100-D/3105-D
Page8–27
DPACuttingUnits:ServiceandRepairs
20252SLRevA