4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT EO18-33031
(Revision Date: Mar. 1, 2017)
4.8 UHF RFID KIT (B-EX706-RFID-U4-US/EU/AU-R)
4-42
3. Fit the Bush in the round hole of the main frame, and pass through it the black connector of the red
interface cable that is connected to the RFID.
4. Fit the RFID module to the bottom of the Platen Holder Block as shown below.
Guide of Attachment Position
<When viewed from the bottom>
Attach the RFID module to the 4 alignment slots
enclosed in circles.
Platen Holder Block
RFID module
Bush
Interface Cable
To Lock
To Next Page
Loading...
