Before Using Copier Functions 15
BEFORE MAKING COPIES
0.Before Using Copier Functions
Default settings
This equipment is under its “default settings” when the power is turned ON, namely, if no setting change has been
applied yet, the equipment’s settings return to the default ones when the energy saving mode is cleared or the
[FUNCTION CLEAR] button on the control panel is pressed. The default settings for basic copy modes at installation
are shown below.
The default settings are changeable. For details, refer to the MFP Management Guide.
Item Default setting
Reproduction ratio 100%
Copy quantity 1
Paper selection Automatic Paper Selection (APS)
Simplex/Duplex 1-sided original -> 1-sided copy
Density adjustment Manual adjustment
Color mode FULL COLOR
Original mode TEXT/PHOTO
Finishing mode When using the original glass:
NON-SORT NON-STAPLE
When using the ADF:
SORT
Feeding mode when using the ADF Continuous feed mode
To Next Page
Loading...
Need help?
General
