HOW TO MAKE COPIES
Specifying the Paper Size 27
0.Specifying the Paper Size
The paper size is automatically detected when you place paper in the drawer(s).
Depending on the administrator’s setting, you can manually change the paper size. For more details, refer to the MFP
Management Guide.
Automatic Paper Selection (APS)
This equipment detects the size of an original and selects paper of the same size automatically.
For the original sizes detectable, refer to the Specifications Guide.
Some original sizes may not be detected with this function. In this case, select the drawer for your desired size
manually.
P.28 “Selecting the drawer for your desired paper manually”
1
Press [APS] on the touch panel.
The paper selection mode is now set at Automatic Paper Selection.
The paper selection mode is set at Automatic Paper Selection by default.
Even if the direction of the paper placed in the selected drawer differs from that of the original, this equipment
rotates the data of the original by 90 degrees to make copies as long as their sizes are the same. (This works on
A4, B5 or LT paper only.) For example, when an A4 original is placed in a portrait direction and A4-R paper is
placed in the drawer, the data of the A4 original will be rotated and copied correctly on A4-R paper.
If “Change direction of original” or “CHANGE DRAWER TO CORRECT PAPER SIZE” appears, follow the directions.
2
Select other copy modes as required, and then press the [START] button on the control panel.
To Next Page
Loading...
Need help?
General
