3.HOW TO USE EDITING FUNCTIONS
Copying the Same Image Repeatedly on One Sheet (Image Repeat) (Color Model only) 89
HOW TO USE EDITING FUNCTIONS
3
Read the following 4 values to specify the area using the left and top scales on the original glass.
X1: From the top left to the left edge of the selected area
X2: From the top left to the right edge of the selected area
Y1: From the top left to the upper edge of the selected area
Y2: From the top left to the lower edge of the selected area
Note that the marks of the original scale have a 2 mm (0.08") pitch.
4
Key in the read values and specify the repeat count, and press [OK].
Press [X1], [X2], [Y1] and [Y2], and then enter the read value correspondingly.
When you want to change the number of times you repeat the image (repeat count), press either [ 2] or [ 8].
The selected area will be copied from the top right corner in a vertical direction.
If the repeated image runs over the paper size, that part will not be copied.
5
Place the original again on the original glass with its face down.
Place with its bottom toward you. Align its top left corner against that of the original glass. When you place the
original in a landscape direction, place it with its top pointing to the left edge of the original glass.
To Next Page
Loading...
Need help?
General
