Table of contents
6 OM 100.EPW400.202002.en
Table of contents
1 Introduction .................................................................................................... 11
1.1 Explanation of symbols ........................................................................... 11
2 Brief description ............................................................................................ 12
2.1 Function of the pressing monitor ............................................................. 12
2.2 Measuring Mode and Configuration ........................................................ 12
2.3 Version .22 ............................................................................................. 13
3 Technical data ................................................................................................ 14
3.1 General technical data ............................................................................ 14
3.1.1 Power supply ............................................................................... 14
3.1.2 Hardware configuration ................................................................ 14
3.1.3 Connections ................................................................................. 15
3.1.4 Digital inputs ................................................................................ 16
3.1.5 Digital outputs .............................................................................. 16
3.1.6 USB ............................................................................................. 17
3.1.7 Ethernet ....................................................................................... 18
3.1.8 Environmental conditions ............................................................. 18
3.1.9 Electromagnetic compatibility in line with EC directives ................ 19
3.1.10 Sensor: analog standard signals .................................................. 20
3.1.11 Sensor: supply voltage ................................................................. 20
3.1.12 Screw sensor with standard signal output .................................... 20
3.1.13 DMS signals ................................................................................. 21
3.2 Overview of built-in version ..................................................................... 22
3.2.1 Mechanical specifications ............................................................ 22
3.2.2 Dimensions of installation housing with two slots ......................... 23
3.2.3 Dimensions of installation housing with three slots ....................... 23
3.2.4 Hole pattern of installation housing (rear view) ............................. 24
3.2.5 Built-in version: digital inputs I0 – I15 (37-pin connector) ............. 25
3.2.6 Built-in version: digital outputs Q0 – Q7 (37-pin connector) .......... 26
3.2.7 Built-in version: pin assignment, DMS force transducer (channel
Y) ................................................................................................. 27
3.2.8 Built-in version: pin assignment, analog signals (channel Y force /
channel X distance) for analog standard signals .......................... 28
3.2.9 Built-in version: pin assignment, analog standard signals ............ 30
3.3 Overview of wall-mounted version .......................................................... 32
3.3.1 Power supply ............................................................................... 32
3.3.2 Dimensions of wall-mounted version ............................................ 32
To Next Page
Loading...
General