Configuring the EPW 400
OM 100.EPW 400.202002.en 75
6.2.13 Force 2
To teach, click on button 'Teach'.
Read in the current electric measuring signal.
Tap on the 'Force 2' input field.
A window with a numerical tap field will be displayed:
Enter the value of the measuring value to be displayed for the electric measuring
signal and confirm this value with the 'Enter' button.
It is also possible to enter the electric measuring signal numerically by tapping on the
input field.
Close the window 'Enter nominal force' by tapping on button 'Accept
calibration'. The configuration will be adopted.
To Next Page
Loading...
General