Configuring the EPW 400
OM 100.EPW 400.202002.en 67
6.1.3 Copy processes
Tapping on 'Copy Process' opens a window in which you can set the
parameters of the current process to be copied to other processes:
By tapping the input fields behind 'from process' and 'to process', the input window
with the numerical keypad will be opened for the direct input of the numbers of the
processes.
You can specify which process parameters to copy from the current process. Tapping
the input fields next to the parameter designations selects (marked by "X") or dese-
lects (empty field) the individual parameters.
In order to copy the selected parameters to one or to several consecutive processes,
tap on the input field behind 'from process'. This opens the input window with the
numerical keypad. Enter the number of the first process and confirm by pressing
'Enter'. Then tap on the input field behind 'until process'. In the input window with the
numerical keypad, enter the number of the last process. A sequence in which process
0 follows process 63 is not allowed.
Attention
When copying data to all or some processes, the previous settings
for these processes will be lost!
Tap on 'Copy' to start the copying process. Tapping on the "Cancel" button will
cancel the process.
To Next Page
Loading...
General