Table of contents
8 OM 100.EPW400.202002.en
6.2.1 Force sensor, channel Y .............................................................. 71
6.2.2 Nominal force of the force sensor (Nominal load) Version 22 ....... 71
6.2.3 Nominal force of the force sensor (Nominal load) ......................... 72
6.2.4 Offset force sensor ....................................................................... 72
6.2.5 Force sensor offset adjustment .................................................... 72
6.2.6 Offset limit force sensor ............................................................... 73
6.2.7 Forced offset force sensor ........................................................... 73
6.2.8 Source force sensor ..................................................................... 73
6.2.9 Nominal characteristic value of force sensor ................................ 73
6.2.10 Filter ............................................................................................. 73
6.2.11 Force sensor calibration ............................................................... 74
6.2.12 Force 1 ........................................................................................ 74
6.2.13 Force 2 ........................................................................................ 75
6.2.14 Distance sensor ........................................................................... 76
6.2.15 Distance sensor Version 22 ......................................................... 76
6.2.16 Nominal distance of the distance sensor (nominal load) ............... 77
6.2.17 Distance sensor offset.................................................................. 77
6.2.18 Offset adjustment of distance sensor ........................................... 77
6.2.19 Offset limit of distance sensor ...................................................... 78
6.2.20 Forced offset of distance sensor .................................................. 78
6.2.21 Filter ............................................................................................. 78
6.2.22 Distance sensor calibration .......................................................... 79
6.2.23 Measuring parameters ................................................................. 81
6.2.24 Measured data acquisition (measuring parameters) ..................... 81
6.2.25 Distance rising ............................................................................. 82
6.2.26 Distance rising or falling ............................................................... 82
6.2.27 Force or distance change ............................................................. 82
6.2.28 Time-triggered ............................................................................. 82
6.2.29 Insert max. force at the end of the curve ...................................... 83
6.2.30 Start/stop condition ...................................................................... 83
6.2.31 Distance-triggered ........................................................................ 83
6.2.32 Force-triggered ............................................................................ 84
6.2.33 Start/stop from PLC ..................................................................... 84
6.2.34 Switching points ........................................................................... 84
6.2.35 Configuration I/O .......................................................................... 85
6.2.36 Configuring the analog outputs .................................................... 87
To Next Page
Loading...