119
2017/06
13.10 Change Admin Password
Please define an individual password for administrator rights.
Default password "password"
Change password
Change the password for the device in the web server.
Write the changes into the device via "Submit".
Restart the device (power cycle or pressing the SET button for approx. 3 seconds).
The device has accepted the new settings, the settings have become active.
NOTE
For security aspects when working with the web server, please observe the notes under
Safety in the Web Server, page 111.
NOTE
A reset of the device to the default-settings using the switch position
900 "F_Reset" (see also Factory Reset (F_Reset), Switch Position "900", page 21) or the
Button "Reset to Factory Defaults" (see also Reset to Factory Defaults, page 123) also
resets the password to "password".
Fig. 27: Change Admin Password
NOTE
"Reset" only resets the changes done in the web server mask back to the original values.
The function does not influence the device itself.
To Next Page
Loading...
Need help?
General
