Configuring
Hans Turck GmbH & Co. KG | T +49 208 4952-0 | F +49 208 4952-264 | more@turck.com | www.turck.com
22
5.2.9 Address Setting via DTM
In a respective frame application e.g. PACTware™, the Turck DTMs allow direct access to Ethernet.
The IP address, as well as the subnet mask of the Ethernet devices, can be changed according to the
application by using the Busaddress Management function of the BL Service Ethernet interface
(TCP/IP) in the DTM.
Further information about using the DTMs can be found in chapter 14, Access via Turck DTMs in
PACTware™, page 125.
5.2.10 Address Setting via Web Server
The device's network settings can be changed under "Network Configuration" only by users having
administrator rights.
Further information concerning the web server of the TBEN-L devices and it's use can be found
under chapter 13, The Web Server, page 111
.
5.3 SET Button
The Set-button is placed left to the rotary coding switches under the cover at the device.
Pushing the Set-button causes a device-restart
.
Fig. 3: SET button
ATTENTION!
Protective cover opened
Protection class IP65/IP67/IP69K not guaranteed
Screw the protective cover over the switches firmly
Check if seal of the protective cover is correctly placed
To Next Page
Loading...
Need help?
General
