11
2017/06
3 For Your Safety
The product is designed according to state-of-the-art technology. However, residual risks still exist.
Observe the following warnings and safety notices to prevent damage to persons and property.
Turck accepts no liability for damage caused by failure to observe these warning and safety notices.
3.1 Intended Use
The devices are only intended for use in industrial applications.
Thanks to the Turck multiprotocol technology, the compact multiprotocol I/O modules for Ethernet
can be operated in the three Ethernet protocols PROFINET, EtherNet/IP™ and Modbus TCP. The
modules detect the bus protocol automatically during the start-up.
The TBEN-Lx devices provide eight M12 female connectors for the connection of up to 16 digital
sensors or actuators.
The devices may only be used as described in this manual. Any other usage shall be considered
improper and Turck shall not be held liable for any resulting damage.
3.2 General Safety Instructions
The device may only be assembled, installed, operated and maintained by professionally trained
personnel.
The device may only be used in accordance with applicable national and international regula-
tions, standards and laws.
The device only meets the EMC requirements for industrial areas and is not suitable for use in res-
idential areas.
To Next Page
Loading...
Need help?
General
