Thursday, May 14, 2009
See Scanner Info
This menu lets you see some information about the scanner, including the memory usage.
Select from the following items.
% Memory Used
Firmware Version
Press [E / yes / gps] to go to each setting.
% Memory Used
When you select this option, the scanner displays the percent of memory that is used, the number and
percent of systems, sites and channels that are created.
This display is as follows.
Memory Used: 62%
SYSTEM 135: 27%
SI TE 921: 92%
CHN 15758: 63%
The Value is displayed until you press any key and return to the previous menu.
Firmware Version
When you select this option, the scanner displays the firmware version as "Version #.##.##".
And the serial number of the unit is displayed as "SN##############" on the bottom of the screen.
Note：The serial number includes 14 digits.
Press any key to return to the previous menu.
To Next Page
Loading...
