■ Channel group properties
❍ Create a channel in a group
■ Channel properties
Programming a P25 System
To program a P25 system, you'll need to program the required elements in following order:
Create a system
1. Go to the Program System menu and choose New System .
2. The scanner will prompt you for the System Type. Select P25 .
3. The scanner will prompt you for the sub-type. Select Standard trunk .
4. When the scanner prompts you confirm, tap YES .
5. The scanner creates the system with a default name. Select Edit Name if you want to change it.
6. If you need to change any of the system properties, you can do that now. Unless a property is
Required , you can operate the system without changing the default settings.
System properties
All of these options can be found under your scanner's Program System menu. If necessary, the sub-
menu and option name on each scanner are listed beside the property.
Property Option name
Required
None
Recommended
Name
Edit Name
Number tag
Set Number Tag
Optional
Automatic Gain Control (AGC)
Set Audio AGC
Record
Set Record (BCD996XT Only)
Delay time
Set Delay Time
ID format
Set ID Format (DEC/HEX)
file:///C|/Documents%20and%20Settings/POpitz/My%20D...DImage_090515/Manual/StandardP25TrunkedSystems.html (2 of 7)5/26/2009 11:11:54 AM
To Next Page
Loading...
