Uniden BCD396XT - Page 483

234
<COMMAND KBP>
Get/Set Key Beep and setting
Controller → Radio
KBP[\r]
KBP,[LEVEL],[LOCK],[SAFE][\r]
Radio → Controller
KBP,[LEVEL],[LOCK],[SAFE][\r]
KBP,OK[\r]
[LEVEL] : Beep Level (0:Auto / 1-15 / 99:OFF)
[LOCK] : Key Lock status (0:OFF / 1:ON)
[SAFE] : Key Safe status (0:OFF / 1:ON)
Get/Set Key Beep Setting.
This command is only acceptable in Programming Mode.
<COMMAND OMS>
Get/Set Opening Message
Controller → Radio
OMS[\r]
OMS,[L1_CHAR],[L2_CHAR],[L3_CHAR],[L4_CHAR][\r]
Radio → Controller
OMS,[L1_CHAR],[L2_CHAR],[L3_CHAR],[L4_CHAR][\r]
OMS,OK[\r]
[L1_CHAR] : Line1 Characters (max.16char)
[L2_CHAR] : Line2 Characters (max.16char)
[L3_CHAR] : Line3 Characters (max.16char)
[L4_CHAR] : Line4 Characters (max.16char)
If only space code is set in character area, the message returns default
message.
This command is only acceptable in Programming Mode.
<COMMAND PRI>
Get/Set Priority Mode
Controller → Radio
PRI[\r] : Get Priority Mode Setting
PRI,[PRI_MODE],[MAX_CHAN],[INTERVAL][\r]
Radio → Controller
PRI,[PRI_MODE],[MAX_CHAN],[INTERVAL][\r]
PRI,OK[\r]
[PRI_MODE] : Priority Setting (0:OFF / 1:ON / 2:PLUS ON)
[MAX_CHAN] : Priority Scan max channels at once (1-100)
[INTERVAL] : Priority Scan Interval time (1-10)
Get/Set Priority Mode.
This command is only acceptable in Programming Mode.